Job Purpose

This position interconnects wired electrical panels to the environmental test chamber through following electrical schematics/blueprints/mechanical engineering drawings. The position also wires the components to the power panel.

Duties and Responsibilities

Entry Level I

Cuts different gauge wires in pre-determined lengths
Cuts interconnect in pre-determined lengths
Checks in parts received from stockroom against pick list to verify part numbers and quantities
Drills out J-Boxes

Level II

Level I functions
Reads and understands blue prints/specs/electrical schematics
Reads and understands parts list
Reads and understands cut list
Wires switches
Lays out J-Boxes and wire panels

Level III

Level I and II functions
Lays out location of J-Boxes
Lays out and wires a job per engineering drawings

Level IV

Level I, II, and III functions
Performs 110V Job continuity test
Performs point to point verification
Quality checks a job

Department Lead

Coordinates level I, II, III, and IV employees

Qualifications

Possession of High School Diploma or GED required
Preferred: industrial/commercial electrical experience
Comprehension of blueprints, specs, and electrical schematics
Experience with junction boxes, electrical conduit, and wiring
Good math skills
Accurately read a tape measure and wire gauge
Experience using power tools including drill, grinder, cutoff wheel
Ability to obtain the necessary tools for this position: tape measure, screwdriver, channel locks, wire strippers, hammer, nut drivers, crimpers